EKAMET End Caps
End Caps
Standard:
– 2 flipping pieces
– stability through circumferential swage
– Without hole for the pipe
– Packed in plastic bags
Other models and alloys on request.
Standard material: galvanized steel and aluminum.
EKAMET 90° Tee
90 Tee
Standard:
– Equal diameters
– Length of tee: 50mm up to the top of the main pipe
– Tail edge: approx. 10mm
– Overlapping: 30mm
– Screw-holes: Ø 3,2mm
Other models and alloys on request.
Standard material: galvanized steel and aluminum.
EKAMET 90° Bend
90° segment bend
Suitable for EKAMET straight jackets
Standard:
– C / E4-swage left descending
– 1 start and 1 end segment
Delivery form: single plugged segments, not screwed
On request: A, B and D swages, special bends, 45°-bends, flat segments, other number of segments, special alloys, etc.
Standard material: galvanized steel and aluminum.
EKAMET Straight Jackets
Round jackets, cylindrical rounded, length approx. 1 m
Standard :
– 1 x positive, 1 x negative swages for connection
– 6 screw-holes (Ø 3,2 mm) per jacket
– Overlapping: 3cm
– Suitable for EKAMET segment bends
On request: conical hole line, 10 screw-holes, drainage holes, slip-swages, special swages, special alloys, etc.
Standard material: galvanized steel and aluminum.
EKAFIX Tools ald Accessories
Tools and accessories for the EKAMAT-system, and for EKATHERM-FL soft boxes
– cutting table
– roll knife
– rivets and rivet tools
– tacker
– clipses
– etc.
Pricelist
Operating instructions for cutting table
Flyer for foil-cutters
Directions for use of EKAFIX Tackers
Part list for EKAFIX Tackers
